Page 1 of 1

Exploder Install

Posted: Mon Mar 08, 2004 2:45 pm
by tomsdad
I'm thinking of mounting my MCS2000 in my 1998 Explorer under the rear passenger seats and place the remote head on an overhead "shelf-it" shelf.

Does anybody know if the MCS umbilical will fit behind the pastic mouldings on the A pillar?

Steve

Posted: Mon Mar 08, 2004 4:13 pm
by jim
no problem.

Posted: Mon Mar 08, 2004 4:42 pm
by mikerabbit
How are those shelf-it units is their a decent amount of room, Could ou mount say a low power spectra in it? I am thinking of getting one for my Grand Cheerokee.
Mike

Posted: Wed Mar 10, 2004 11:16 pm
by thebigphish
i think depending on the vehicle, the unit might not be deep enough for the radio to mount flush with the edge of the shelf-it (althought some people say i would be the only one to know :D ). It would be close.

However, in terms of sturdiness, a lowpower spectra would turn in to quite the projectile in sharp maneuvers, and i'd be REAL careful about mounting a brick above my head or above the ladies head (that's the more important of the two, i can heal, she will kill)...

Posted: Thu Mar 11, 2004 3:37 pm
by tomsdad
mikerabbit wrote:How are those shelf-it units is their a decent amount of room, Could ou mount say a low power spectra in it? I am thinking of getting one for my Grand Cheerokee.
Mike
I've never seen a Spectra in the flesh so have no way of judging if it would fit or not.

But I would be cautious about mounting a radio up there - but there seems to be room a plenty for a remote head or two, plug garage remote, sunglasses, box of tissues and assorted other accoutrements;-)

Steve

Posted: Thu Mar 11, 2004 3:59 pm
by KitN1MCC
i had one in my 89 s10 with the mitrek head on it worked out reeal good