MTR2000 IN MAIN STANDBY MODE
Posted: Wed May 26, 2004 2:10 am
Hi guys is there anyone out there who has setup a main/standby system using 2 MTR2000 radios.
These radios will be connected together so if a fault occurs on the main radio this will cause the standby radio to take over control of the system.
On the Quantar it is possible using the wild card tables and an interconnect cable between the 2 radios.
If anyone has done this using 2 MTR2000 radios could they please send me the information needed and the wiring diagram.
Many thanks
KIERAN.
These radios will be connected together so if a fault occurs on the main radio this will cause the standby radio to take over control of the system.
On the Quantar it is possible using the wild card tables and an interconnect cable between the 2 radios.
If anyone has done this using 2 MTR2000 radios could they please send me the information needed and the wiring diagram.
Many thanks
KIERAN.