Batboard

Greetings,
I am using the public service mike on my JT1000 and it works fine except the three buttons do not function although I have programmed the buttons on the radio with the RSS. I have picked thru the software and can not find a screen to program the buttons on the mike. Any advice on getting these buttons to work would be greatly appreciated.

Thanks...Neil

there is only one button on the speaker mic's....now on a public safety mic there is a volume hi/lo switch...but thats it....I dont know what kinda speaker mic you have or what kinda crack you've been smokin but I'm sure many will agree with me.

There is a three button mic for the mcs mobile radio that will work on a jt1000 with the right jack. Could it be someone has put a JT connector on an mcs mobile mic??

Yes it looks like a change in the mic there is no jt1000 part for this mic.

BTW, this "three button" mic has a resistor matrix for the buttons. Two of the buttons have a series resistor and one is a short when pushed all on the same lead. Each button has a resistance in series like the control buttons on the R1225.
The one I have seen is in the same sealed housing as the HT1000 speaker mic with a eight pin RJ45 jack, but have'nt found a speaker in it.

Ok I'm back from smoking crack.

The part number on the mic is NMN6192A. If there is a website for looking up these partnumber and prices, I would appreciate a link.

Thanks...Neil

Easy question to answer. IT wont,cant,does not, and never will. You have a rigged up mic that was never intended to go on a jt1000
or any other jedi for that matter. just because the cord for a jedi spk/mic has a modular end on it does not mean it will function correctly on any head just because it has a modular recepticle. The basic functions may but any beyond that, NO
Hope that clears up that one. Phrawg