Batboard

Hi!

I have 16 CH, VHF high band P210 . I use original RIB and cable . I can read and write to radio with no problems. When I got the radio it was programmed with all 16 channels. I programmed radio with new freq. but when I read it I can see that channels from 9 to 16 are not programmed with new freq. .

To make it short I can not programm channels from 9 to 16.
Any idea ??

It's an 8 ch codeplug in a 16 ch radio ?


CHART

Hi!

Anybody out there to share 16 CH VHF high band codeplug for P210

sb wrote:Hi!

Anybody out there to share 16 CH VHF high band codeplug for P210

You can create a new 16 channlel codeplug in the P210 Rss, I know, I've done it before. Create a new codeplug with the correct bandsplit and 16 channel model number than program it in.

Frank

Hi!

When I read the radio this is what I get:




Radio is recognized as 16 CH and programmed as 16 CH .
I programm new freq. list into radio but when I read it back channels from 9 to 16 are programmed with old data !?

sb wrote:Hi!

When I read the radio this is what I get:




Radio is recognized as 16 CH and programmed as 16 CH .
I programm new freq. list into radio but when I read it back channels from 9 to 16 are programmed with old data !?

Is the radio a real 16 channel radio?? Or an 8 channel model with a 16 channel codeplug in it??? What doe the model tag say??

Hi!
It is 16 channel model.

Model: MDH33RFU9100

http://www.oppermann-telekom.de/ht800-modelle.html

Hi!

I programmed radio with good codeplug and it looks fine at first. Radio acept all 16 channels. But when I edit the freq. channels 9-16 went back to old values. I tried all kind of stuf and finaly got all 16 channels programmed, but the radio was recognised as UHF !?
Then I change it to VHF in hardware conf. and programm it again and it works for now.

ey yo sb contact me will you please?