Page 1 of 1
code 3 led-x 2100
Posted: Tue Nov 30, 2004 5:23 pm
by schlab
the car i received last week has all 6 led-x modules burned out in the rear. all the ones burned out were the amber modules for the built in arrow-stick. the install was done by another shop and is running off of a federal-signal control box, i just thought it was real weird that all 6 modules were burned out, just wondering if anybody could help so i have a direction to work from
thanks[/b]
Posted: Tue Nov 30, 2004 6:18 pm
by Tech225
Have you tried swapping the modules around in the bar to make sure they are actually burned out? Wired properly, it shouldn't matter what kind of switching system you're using.
Posted: Tue Nov 30, 2004 6:54 pm
by FFParamedic571
I would check the signalmaster controller. Ive seen where the plugs have come out or the power wire is not making contact..
Posted: Thu Feb 10, 2005 9:08 pm
by 1STOPCOPSHOP
ACCORDING TO CODE3 THEY HAVE HAD ISSUES WITH THE GROUND CIRCUIT IN THE LED BOARD . THEY WILL REPAIR ASAP UNDER WARRANTY JUST CALL CODE 3 DIRECT. I HAVE HAD 2 LEDS GO BAD AND SO FAR ONLY AMBER HAVE HAD PROBLEMS
Posted: Fri Feb 11, 2005 9:57 am
by KitN1MCC
just another Reason why not to Buy Code -3