Page 1 of 1

Mobile Vision System 5 Install

Posted: Sat Dec 04, 2004 5:40 am
by Blazeorange
Anybody got a System 5 Install Manual.........?

A customer bought a used one and wants it installed. It looks pretty much straightforward (like the System 7's that I've done) but I only have an install and user's guide for the System 7's.

The System 5 looks a few years older than the System 7's this customer uses now. The budget's shot so he needed a system to "run and gun" with at low cost so he went with this. Older but functional, I guess.

I could sure use a listing of what wires need to go where or a .pdf of the manual for the System 5 would be better yet.

Thanks in advance.

Blaze.

[email protected]

Mobilevision 5

Posted: Mon Dec 06, 2004 12:57 pm
by Glen W Christen
Green = reds sense
Blue = siren sense (use optional detector)
Yellow = grill record indicator (provides 12v)\
white = ignition input (environmental)
Red = +12 V input
Brown = auxilary
Black = chassis ground

Posted: Mon Dec 06, 2004 2:57 pm
by Blazeorange
Thanks. I installed it just like a Mobile Vision System 7 and it works fine. Had a problem with the rear seat microphone and I think I got that worked out.

There's a really thin (22 Ga? maybe) wire coming back from the main harness that's tied in with the monitor plug. Is this a ground for the monitor?

Thanks.

Blaze.

Mobilevision

Posted: Thu Dec 09, 2004 5:49 am
by Glen W Christen
I've never seen a separate lead like that. Sorry, I don't know.