Batboard

Subject line says it all

I'm looking for the part number for the keyloader cable that will work with the XTS5000

Thanks,
Tom

TDN9390

Hi,

TDN9390D comes back as

"CABLE KEYLOAD MTS2000"

Does the MTS and XTS use the same cable??


Tom
N1AML

They do use the same cable.

Thanks! I REALLY hate talking on the phone - which was why I posted the question here , but I just called M and confirmed that was true.

I didn't realize how cheap they were, so I made my own. Now that I FINALLY got an MOL account, I see they aren't that bad. Lot's of other things aren't as bad as I origianlly thought either.

rescue, do you still have the diagram to make one? my searching skills are eluding me if its posted around here..

thanks!

I do, but I'm on the way to work right now. I'll set you up later today!

I take NO credit for this map-out of the cable. It does work very well! I had a link to the website that hosted it, but have lost it somewhere. Correct me if I'm wrong, but I think this is another r0f original.

MTS / XTS KVL Cable TDN9390D

KVL Connector, Face view, Lip/Screw Top

LIP HERE

1 o o 6

2 o o 7

3 o o 8

4 o o 9
--------><THUMB SCREW HERE
5 o o 10




Radio Connector, Face View, Spring/Clip Top

SPRING CLIP HERE

----o 7
1 o
----o 8
2 o
----o 9
3 o
----o 10
4 o
----o 11
5 o
----o 12
6 o
----o 13


KVL 1 --- NOT CONNECTED
KVL 2 --> RADIO 4,5,6
KVL 3 --> RADIO 13
KVL 4 --> RADIO 10
KVL 5 --> RADIO 11
KVL 6 --- NOT CONNECTED
KVL 7 --> RADIO 4,5,6
KVL 8 --> RADIO 13
KVL 9 --> RADIO 10
KVL 10 --> RADIO 11

(Edit: to allow for adding dashes. Spacing doesn't stay after posting, so dashes had to be added to keep the propper spaces on the connectors. Sorry for the confusion).

outstanding man! i appreciate it

For those seeking to roll thier own. I suggest following this Correct MX diagram, not the one above


http://www.batlabs.com/images/mx300mic.gif

Umm .. isn't that a mic schematic?

The subject here is a keyloader cable

hamptonbeach wrote:Umm .. isn't that a mic schematic?

The subject here is a keyloader cable

I think ArmsonOeg is saying that the linked drawing is easier to read.

Aren't we confusing Jedi and Saber a bit anyway?

I just tried making this cable and I can't get it to work. I have a TKN8531B hirose cable that works with the saber hirose D adapers. I found a female hirose and installed that in a jedi connector where the audio jack normally goes. I figured I could wired up the right pins and have a jedi end for my XTS.

The diagram above shows the kvl pins basically bridged all the way across except the two top ones. I tried making the cable with the pins bridged and without but nothing works.

Does anyone have a real deal diagram of the wiring for a Jedi / XTS cable?