Batboard

I am looking for a bracket or panel to mount a CDM 1250 into a 19" rack. Has anyone found a dealer for these. I would appriciate any help

Thanks

There have been a couple of threads about this in recent history.

http://batboard.batlabs.com/viewtopic.p ... rack+mount

Thanks, I did try a search "cdm1250 rack mount" a couple of different ways. I remember seeing this before but couldn't find it.


Thanks again

We just buy a Chatsworth shelf from Graybar and mount the unit's bracket to the shelf. Yeah, it's sleazy but it works well. The rear of the shelf is used to strain relief cables by drilling a hole or two for wire ties.
Good luck, Bob

You could check with Mark over at Storm Lake and see where Alpha Wireless had this made:

http://www.bv911.com/images/Dispatch/BV ... ackup2.jpg

Heck, that might make a nice little road trip....

You can also just get some blank face plate, cut it to fit and drill the side holes, and then cut an opening for a flush mount bracked for the CDM radio.