Batboard

Posted: **Mon Apr 18, 2005 6:04 am**

Can an Astro Saber III/XTS3K(35K) do non-standard PL's as well as what is the freq split???

My XTS5000 can not do non-standard PL's so I guess I am going to have to get rid of it and was either looking at another /\/\ digital or having to go over to Kenwood Digital but then would have to dump the XTS.

Can anyone help answer these questions???

Posted: **Mon Apr 18, 2005 5:14 pm**

Why couldnt you ask this in the other post that you started thats dealing with the same thing?

Posted: **Mon Apr 18, 2005 8:03 pm**

Based on the fact that this is about an ASIII/XTS3K(35K).

So do you know???

Posted: **Mon Apr 18, 2005 9:06 pm**

No, you can't. Not without redesigning the firmware. The codeplug info being progrmmed into the radio only gives the PL tone a hex value that the firmware recognizes.

You would have to change the firmware to say "when programmed with hex value EC, then produce 123.0hz"

It's essentially an internal cross-reference table custom to the firmware.

sorry.

tpg

Batboard

ASIII/XTS3K(35K) non-standard PL's/freq split.

ASIII/XTS3K(35K) non-standard PL's/freq split.