Page 1 of 1
TX lock up on W9
Posted: Sat May 07, 2005 4:22 pm
by Zero dbm
Curious if anyone has any thoughts about my UHF astro spectra W9. It will work perfectly on a trunk system with nothing but great performance, but when I use it on a simplex mode, it will intermittently lock up in TX. I have to power down and restart to get it to clear.
Now, I haven't put much time into troubleshooting it yet, as I thought I would check with the group here first.
Thanks
Posted: Sat May 07, 2005 7:02 pm
by mtr12222
I have the same problem with a H38 flashed AS III. If a channel is changed just after TX'ing the transmitter locks up. The problem is intermittent and has only occured in one zone ( the one the radio is in most often). The volume power off is dead the only way to reset the radio is to disconnect the battery. This radio is going back to the depot soon. If you figure this out let me know.
Flashcode
5901080000000
7.14.00
DSP
8.03.01
Posted: Sat May 07, 2005 9:41 pm
by The Pager Geek
Sounds like a firmware issue (on both accounts.)
Is that Astro Saber a parts built? The host and DSP don't line up....
(Host 7.14.00 should be 8.02.08 DSP....)
tpg
Posted: Sun May 08, 2005 4:22 am
by mtr12222
Nope. The radio was depot upgraded for IMBE and a 1meg VOCODER from a VSELP model. The depot at that time also flashed it for H38.
The Host is 7.14.00
DSP N08.03.01
EMC 3.56
Posted: Tue May 10, 2005 7:21 am
by Zero dbm
The W9 that is doing this is VSELP. The radio is not parts built.
Patriculars:
AMR75100
I050102
EMCR0100
000004-000000-6