Batboard

I have a question on this, I have not tried to reprogram a radio yet. I want to put a GTX on the 900 ham band. I am interested in repeaters and simplex. So does that mean on the preticular GTX that I want (M11WGD4CB1AN) I will get 10 conventional/10 trunking systems/8 trunking talkgroups. So I can only use the 10 conventional channels for repeaters and simplex. The other 18 will not be able to be used correct?



Thanks!
Bob

RidgeRunner wrote:I have a question on this, I have not tried to reprogram a radio yet. I want to put a GTX on the 900 ham band. I am interested in repeaters and simplex. So does that mean on the preticular GTX that I want (M11WGD4CB1AN) I will get 10 conventional/10 trunking systems/8 trunking talkgroups. So I can only use the 10 conventional channels for repeaters and simplex. The other 18 will not be able to be used correct?



Thanks!
Bob

Correct.

Thanks for clearing that up!

FYI,

You can delete all but 1 of the trunks and groups then program in all 10 of the convential channels - the helps clean up the display and moving from channel to channel.

Dennis

Thanks good Idea I'll remember that!

Has anybody tried to hack the MDF file, if there is one? I recently changed a Maxtrac from 10,10,and 10 to 20 conventional,and 0 trunking.

I am sure it can be done, if it has to a maxtrac. I guess its a matter of someone trying to do it.

I'm trying to program a GP600 trunked mtp1327 in ham band, now the range of this radio is 403-433Mhz, what i do to program few channes out of this range?

I hope is similar to a GP900, i'm using DDPS_DS.exe to run and read the radio, but i can't program any channel up to 433 MHz.

The soft have a pass to get in lab's soft, to adjust frecuency and others, whats is this password?

i have to a p100 VHF radio, what's is the way to get out of range this radio too??

Best Regards
Francisco.

If anybody need some answers about MPT1327 i can respouse, becose i work in this trunking type.