Batboard

Hi guys this one has me stumped, I have looked at all the posts in the search, but I can't seem to find a correct answer so I am asking the experts, I am trying to set up mdc from a gp300 to a pro9150, I have set up numorus ht1250's and they work fine, but this radio just won't decode I have kept the same settings in both radios just changed the id #, when the transmiting radio keys I can hear the mdc, but no id # comes up, so i did some changes to both radios but no luck, I even created a seperate freq on both radios and a new mdc for both but I cannot get the 9150 to decode. could it be the 9150 is unable to decode a mdc or does the 4 lines of info on the 9150 take up too much room and leaves no room for the decode.
Jeffrey

the 9150 is the same as the 1550 except it won't do LTR or passport. Check your programming again, it can and has been done on the PRO9150

Are you selecting MDC as the rx signalling system in the conventional personality? If you don't, it'll do exactly what you're describing.

Todd