900 spectra not transmitting pl-any thoughts?
Moderator: Queue Moderator
- sglass
- Batboard $upporter
- Posts: 2282
- Joined: Sat May 18, 2002 2:03 pm
- What radios do you own?: sonic screwdriver
900 spectra not transmitting pl-any thoughts?
no pl tx at 902.725 or 927.725
There is a hacked version of Spectra LAB floating around [might be version 5.03 or something close to that] that lets you put in the out of band frequencies but your radio ends up with this PL problem.
If you start with the current regular [not LAB] RSS and 'adjust' the out of band limits as described on the Batlabs site - you should be able to set up ham frequencies in your Spectra without losing your PL.
If you start with the current regular [not LAB] RSS and 'adjust' the out of band limits as described on the Batlabs site - you should be able to set up ham frequencies in your Spectra without losing your PL.
Yup bug in the RSS software. I've run across it a lot on the 900MHz radios. One version shows it programmed. Go into lab and no TX PL... just ran into it again last night. I finally figured it out with a service monitor that it plain wasn't transmitting the PL despite the fact the software said it was programmed.
Kurt
Kurt
I am <I>NOT</I> Hamsexy
- sglass
- Batboard $upporter
- Posts: 2282
- Joined: Sat May 18, 2002 2:03 pm
- What radios do you own?: sonic screwdriver
yeah wacky, it doesn't do that on uhf rigs thoughn1pfc wrote:Yup bug in the RSS software. I've run across it a lot on the 900MHz radios. One version shows it programmed. Go into lab and no TX PL... just ran into it again last night. I finally figured it out with a service monitor that it plain wasn't transmitting the PL despite the fact the software said it was programmed.
Kurt
heh heh, brings a smile to my face.Kurt
_________________
I am NOT Hamsexy