Batboard

Gents,

I have a few Minitor II pagers that I want to page different than the factory settings. Instead of the A tone being the common tone, I would like to make the changes required to have the common tone changed to tone B.

Here are the two sets of paging tones I would like to install.

First Pair:
Tone A: 457.9
Tone B: 1092.4


Second Pair:
Tone A: 879.0
Tone B: 1092.4

1092.4 is tone B in both sets of tones. Which jumpers would I have to cut or short to accomplish this AND where can I find the jumpers in the Minitor II?

Thanks guys,
Tim

http://www.batlabs.com/minitor.html

Thanks PJ. It probably would've helped if I read the page thoroughly. I didn't see the link for the circuit board.

You guys are great.


Tim