Page 1 of 1
Toyota tacoma install
Posted: Wed Jul 20, 2005 5:35 pm
by ryang1
Ok all I finally got my tacoma and i am strating the install I have 4 strobes that are going in the front and 2 for the rear for now in the fron t they are going to go in the headlighta and i am going to try to put them in the fog lights i have leds in the grill and strobe for the dash. now i am trying to figure out how and what kind of radios to install i need high low and uhf. probable going to order a sti-co antenna this week. any help would be great unfortanly there is not a tone of room to mount radios.
thanks again ryan
ps i will try to get some pictures to post once i get going
Posted: Wed Jul 20, 2005 7:03 pm
by akardam
As far as radios go, I've done overhead mounting and done stuff with a custom console I built to fit over the stock center console. There just isn't a lot of room in the Tacomas unfortunately.
i have an 04 prerunner extra cab
Posted: Sun Jul 24, 2005 7:56 pm
by uman18
i have an 04 prerunner extra cab. i took out the trim where the 2 extra cig lighters are, right under the ash try and put a BC780xlt scanner and used one of the cig lighter wiring to hook it up and relocated the other cig light outlet to right below the shifter on the other part of the console. i also have a remote mount vhf cdm1250 that i mounted on the console. at one point i had a Gm300 remote mount inside the very bottom compartment of the are rest. fit perfectly but needed more channels. i'll post pic soon