Batboard

Fellas,

I have an '02 Dodge Ram pick-up and I want
to install a JottoDesk short stack 9" console.
It will house a Spectra, BC-785, & a Maxtrac.



What am I doing wrong here?
I can't embed my image here.

The image can be viewed at http://www.kb5ako.dyndns.org

Does anyone else have a setup like this?
How about pictures?

Suggestions are welcome.
The existing 40/20/40 & arm rest/console stays.

I'll post pictures of it after installation.

Victor

You want to embed the url of the image itself, not the url to the page that displays the image, thusly:


(without the spaces between the tags and the url)

definately a nicer looking console than the one i got, but it might be a little low of a reach in a truck. especially if you're like me and ride with the center seat back flipped down as an armrest. i have an '04 and went with an add-on section from a gall's console. not as much room in the faceplate area, but a few inches taller. puts it right where your fingertips would fall if your hand was hanging off the front of the armrest. here's a pic. you're looking at the front section only. needed a bit of work since it's not meant to be a stand-alone console, but it's working out ok so far.

Ugggh, a Galls product.

AHH, the obligatory galls-bashing. lol. i know but like i said, it's the only one that i found that was high enough for me. please if there are better options, both victor and myself would love to see them.