Page 1 of 1
gp300-5t codeplug error 1
Posted: Mon May 13, 2002 12:15 pm
by cajkovski
Well, I have this problem, I was programing my radio gp300-5t actually, I was in mode radio aligment, when power turned off I mean on power of my computer, now my radio blinks (red, yellow and green), I can'
t read or write to radio. I allways get codeplug error 1.
What to do?
73 from Bosnia!
GP300
Posted: Mon May 13, 2002 1:35 pm
by Tom in D.C.
The RSS program manual which I have says that a Code 1 error message indicates a parity error with the probable causes being a bad connection to the radio OR a bad logic board. The fixes are to check the connections and/or to replace the logic board.
I don't know if this applies to your 5T model GP300. Good luck.
Tom, W2NJS
...in Washington DC
Re: gp300-5t codeplug error 1
Posted: Tue May 14, 2002 7:16 am
by Metradio
cajkovski wrote:Well, I have this problem, I was programing my radio gp300-5t actually, I was in mode radio aligment, when power turned off I mean on power of my computer, now my radio blinks (red, yellow and green), I can'
t read or write to radio. I allways get codeplug error 1.
I got a GP300-5T about a year ago from a radio show in the UK, it did the same thing: blinked Red, Orange Green, unable to read or write...
This one gave the error 4..
I fixed it by getting a copy of GP-Tools and running it on a S L O W computer and inspecting the code plug, the GP300-5T sprang straight back to life . The information I got from the BatLabs GP300 page..