Page 1 of 1
GM1200 Conventional Mode
Posted: Fri Nov 25, 2005 8:50 am
by montegrande
Hallo
I need help for use GM1200 in conventional mode!!!
when my radio start led green blink and a Z is in display.
There is a way to switch it in conventional mode and use for talk with HAM radio?? I need only 4 conventional channel!!
Please Help me
Max
GM1200
Posted: Fri Nov 25, 2005 7:31 pm
by wmd
Hello Just push the P button until the radio Go's into conventional mode then let go of the P Button
Posted: Sat Nov 26, 2005 1:47 am
by montegrande
OK!!!!!!!!!!!!!!
Radio is in conventional mode!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Thanks!!!!!!!!!!!
Max
Posted: Sat Nov 26, 2005 3:46 am
by montegrande
Sorry have another problem...
Now , in conventional mode radio transmit OK but i don't hear nothing... red led blink and no audio.....
My GM1200 have internal loudspeaker... pin 1 & 2 of Accessory Connector are Jumped..when radio start i Hear beep
1200
Posted: Sat Nov 26, 2005 6:55 pm
by wmd
Are you using DOS or DPS software to program the radio?
Posted: Sun Nov 27, 2005 4:05 am
by montegrande
..Was a stupid flag!!
Now i can hear...
but another problem!!!
I can Tx only 5 seconds... after a beep and..stop TX..
there is a timers? or a protection???
Please help me!
i use DPS R00.01.10 software.... dos rss 03.03.00 do not support this model!
Can you help me? If you wont i can send you a print of all configuration!
Posted: Sun Nov 27, 2005 11:40 pm
by Andreas
Do a firmware update,this will fix the problem.
Andreas
Posted: Sun Mar 05, 2006 10:44 am
by montegrande
have find that is a timer TTs in network configuratin......is 0 sec and so after 5s alert cut off.. i set this value at max (60sec) and so i can talk for 60s but i need disable this options!!!
Can you help me to disable this function... I am in conventional mode...Why network timers are on???
Thks
Max
Posted: Sun Mar 05, 2006 11:09 pm
by Andreas
Only flashing the radio into MC2100,will disable the timer complete!
Andreas