Batboard

Can I parallel a 136.5 and a 82.5 vibrasponder on the input and the output so two different parties can use the same repeater but not have to hear each others traffic? Or is there an easy way to do this another way? My pl board has one slot for in and out reeds.

<font size=-1>[ This Message was edited by: ka9vxs on 2001-09-10 20:50 ]</font>

<font size=-1>[ This Message was edited by: ka9vxs on 2001-09-10 20:50 ]</font>

The best, easiest and most versatile option is to add a Repeater Controller to your MSR. They go for around $75.00-$150.00 on E-bay and will allow multiple users.

We added multi PL capabilities using three different types of decoding/encoding.
The simplest is to add a Com-Spec TS32 tone PL decoder/encoder, two diodes, a resistor and a 12volt low power reed relay from Radio Shack.
The TS-32, diodes, resistor and the relay are wired to the mother board/control board. Only adjustment is for transmitt PL tone deviation.
If you need the wiring info, let me know.