Page 1 of 1
Programmingcabel connection for GM950
Posted: Sun Jan 15, 2006 12:22 am
by JP
Folks,
I have an GM950 the radio model is M08KHFE91AN this is a mobilofoon whitout a head. The buttons and display are placed in the microfoon who is connected to the front. (See Gallery Batlabs) Can you tell me the connection for the programming cable and where to place the back or the front.
Greating JP
Holland.
Posted: Sun Jan 15, 2006 5:45 am
by Ed
JP,
The GM-950 with HHCM has to be programmed by the accessory connector. Alternative you can swap the head of a regular GM-950, so you can programm by the microphone connector.
Ed
Posted: Sun Jan 15, 2006 6:19 am
by wavetar
It should be the same as the MCS2000 cable:
-edit-
My bad...it isn't.
Todd
Posted: Sun Jan 15, 2006 6:22 am
by Ed
Wavetar,
The GM-950 doesn't have the RS-232 connector. The GM-950 has a 16 pins connector on the back.
Ed
Posted: Sun Jan 15, 2006 6:26 am
by wavetar
Ah, it looked like the MCS series. Is there a pinout for the cable he needs?
Todd
Posted: Sun Jan 15, 2006 6:31 am
by Ed
wavetar wrote:Ah, it looked like the MCS series. Is there a pinout for the cable he needs?
Todd
Pinnout of the 16 pins is on Batlabs.(GM350/950 section).
Ed
Posted: Sun Jan 15, 2006 6:55 am
by wavetar
I see...the actual GM950 page only contains a single page of bandsplit information, I didn't realize the GM350 had the correct info. Thanks!
Todd
GM950
Posted: Sun Jan 15, 2006 9:32 am
by JP
Thanks for the information a have no head for the GM950 and must programed the Mobilofoon on the connector backsite.
Greatings JP