CP1250 Cradle - Part #????

RADIO43 · Post by **RADIO43** » Wed Feb 01, 2006 7:46 am

Anyone know the part number on the programming cradle for the CP1250? Thanks in advance.

Radio43

Fuel4300 · Post by **Fuel4300** » Thu Feb 02, 2006 11:52 am

The programming cradle is:

0162481S01

and the cradle plus software and manual is:

PDVN4008A

Both are showing cancelled on MOL.

Fuel

RADIO43 · Post by **RADIO43** » Thu Feb 02, 2006 4:12 pm

Tahnks for the help Fuel4300... Radio43

otter9309 · Post by **otter9309** » Mon Apr 17, 2006 7:21 am

I have two leads from an advisor cradle, and it worked fine.

EEnerd · Post by **EEnerd** » Tue Apr 18, 2006 7:18 am

I was wondering, in general- why you couldn't just use an advisor (or whatever) programming cup and extend the leads to any pager? Don't most all Motorola pagers use a serial interface? I think i remember older pagers using 3 connectors; TX/RX/GND, whereas some newer ones use a 2 pin arrangement; GND and a bidirectional pin which would require commoning the TX/RX pins on the programming cup.