programming cable for Motorola Radius P1225

Max · Post by **Max** » Sun Feb 12, 2006 4:49 am

I am trying to make a programming cable for a Motorola Radius P1225.
I am going to use a drop in charger ,i know that you need to use X2 (data ground) and X3 (data input) from the battery on the rear of the radio ,i just need to find out the schematic for the 25 pin to the rib.So i need to know how to wire the 2 pins in the charger to a 25 pin D.
Thanks in advance for any help.
Fred

bayfire300 · Post by **bayfire300** » Sun Feb 12, 2006 5:14 am

they way mine is as follows:

pin 1 is black x2
pin 15 is yellow x3

pins 4 and 11 are linked together

i took mine apart and thats the way it is .......but my cable has aligator clips on the wires its not goin to a charger cup.......i shouldd make one also
otto

IMBEJames · Post by **IMBEJames** » Sun Feb 12, 2006 5:16 am

http://www.batlabs.com/p1225cab.html

The connections are the same to the db25 as the Maxtrac cable.

X2 ------ pin 1
X3 ------ pin 15

short pins 4 and 11 on the db25, and you should be all set.

Will · Post by **Will** » Sun Feb 12, 2006 6:19 pm

Or: I have one in the For Sale Fourm:

"HLN9359A Programming stand/cable and Rapid charger for the P1225 series radios. Genuine Motorola, in very good condition. "