Batboard

Posted: **Sun Feb 12, 2006 7:45 pm**

It has been along time since I programed any radios. I pulled out my RIB and found most of my software /refernce plugs etc but I couldn't find my notes on where to hook up the wires and I have a model here that I have never attempted before. So with that said anyone that can help me with my list here I would greatly apprecate it.

Radius p50; need to know where to hook wires up and which pins from RIB (ps looking on the internet some sites say you can't change the freq and some say you can, anyone know for sure?)

Radius SP50; again where and what pins from RIB

Radius P110; if I remember correctly the last time I prog one of these I did it through the batery on the four contacts on the back of the battery again where to put the wires and which pins.

Thanks to anyone that can help me out.

Posted: **Sun Feb 12, 2006 8:00 pm**

I would check the actual Batlabs site for radio info and cable info.

Posted: **Sun Feb 12, 2006 9:50 pm**

http://www.batlabs.com/pinouts.html

Posted: **Mon Feb 13, 2006 5:36 am**

The Radius P50 is crystal controlled and PL codes are set by a DIP switch.
Only the SP50 can be programed with a RIB.

Posted: **Mon Feb 13, 2006 6:43 pm**

I feel stupid, I went back and looked at the pin out page again and realized that he sp50 is on there. Old age and bad eyes

On the P50 does anyone know where a list would be to interpret the dip switch = what PL tones. after I read that I found the dip switches behind the batery with a sticker giving the freq.

3 of the p50 have the same freq and they are the ones that we are trying to match the others to anyways because that freq has been assigned to our race team. I will match the 2 sp50, and 2 P110 to them as soon as I can figure out that PL tone.

Posted: **Mon Feb 13, 2006 7:23 pm**

Tex60 wrote:On the P50 does anyone know where a list would be to interpret the dip switch = what PL tones. after I read that I found the dip switches behind the batery with a sticker giving the freq.

I have a manual with both the early model jumper settings and the later model DIP switch settings. Let me know the code you need and I will look it up for you.

Posted: **Mon Feb 13, 2006 9:06 pm**

Model # H44GNU3120AN 1 thru 6 are on and 7 and 8 are off

I really appreciate your help.

Posted: **Tue Feb 14, 2006 7:12 am**

That looks like the default PL setting which is Code XA 71.9

Send me a Private Message if you would like me to look up a specific code setting for you.

Batboard

RIB to radio cable connections?

RIB to radio cable connections?