Page 1 of 1
AS II
Posted: Wed Feb 15, 2006 11:31 am
by wb4bsd
I have an astro saber model 2.
When i press the monitor button i find that the scan comes on and goes off as i press the button.
Currently the scan button is below the PTT.
Any idea's?
Monitor Button
Posted: Wed Feb 15, 2006 12:11 pm
by Hartley
Hi Rusty,
On re-reading... I would guess that there is a short between the two buttons in the flex, causing scan to be triggered along with monitor. Since the buttons are on the radio frame, you may have to do surgery to find out...
73 DE Hartley
Posted: Thu Feb 16, 2006 12:29 pm
by VE9MP
Did the radio act like this since you got it or is it a new issue that just currently came up....
People like to do strange things with Lab.....
Posted: Thu Feb 16, 2006 1:27 pm
by motorola_otaku
I've seen this before on Jedi radios with water damage to the side flex. If it's not too invasive, a few minutes with some cotton swabs and isopropyl alcohol fixes it right up.
Posted: Thu Feb 16, 2006 3:46 pm
by wb4bsd
no one has been in this thing with lab. its a work radio so water damage is more likely. i'll check that and clean it good. thanks guys.