Batboard

Hello. I am creating a new codeplug for my XTS3000 (Using XTS3000 CPS R04.01.04)

I want it so that the Unmute/Mute Rule is set to Standard on All Freq's, and that RX Squelch is set to Mixed Mode, also on all Personalities. (Currently most of these values are different; personalaity depending)

How do I drag and drop from the "Mulitple Record Table"?

Thanks,
-Ray

i think if you use the ++ tab it will copy modes instead of add so you don't have to keep changing new ones.

Theres also a CUR (current) and DEF (default) tab at the bottom of the personality screen.

Select CUR and then press the + key and it will copy the current personality, so then all you need to do is change your freq.

If you select DEF and then press the + key, you will get a system default personality and will have to set up each tab the way you want it.

I dont have any screen shots right now, but maybe someone can post a screen shot for you to help out.

Upgrade to XTS3000 CPS version R05.00.02 (available for download on MOL), it supports a new feature for filling in values in 'table' mode.

List your personality data in 'table' mode. On personality 1, change the unmute/mute rule to standard. Then right-click on the field then click 'fill value down'. It should change the unmute/mute rule on every following personality over to 'standard'.

The same applies to changing your rx voice signal type as well.

I found that if you have a lot of personalities it takes a few minutes for the CPS to perform the fill-in task, so if your computer does not respond it should eventually finish the fill-in and start working again.

Rayjk110 wrote:Hello. I am creating a new codeplug for my XTS3000 (Using XTS3000 CPS R04.01.04)

I want it so that the Unmute/Mute Rule is set to Standard on All Freq's, and that RX Squelch is set to Mixed Mode, also on all Personalities. (Currently most of these values are different; personalaity depending)

How do I drag and drop from the "Mulitple Record Table"?

Thanks,
-Ray