Page 1 of 1
is there a way to refirb a ht1000 mic
Posted: Fri Mar 10, 2006 9:28 am
by explorer1046
Is there a way to take apart a ht1000 mic (NMN6193) and replace the bad/worn parts w/ new parts?
Posted: Fri Mar 10, 2006 9:40 am
by HLA
just the ptt button and the cord, the mic itself is sealed permanently.
Posted: Fri Mar 10, 2006 7:53 pm
by phrawg
It WILL open upon application of a 3Lb persuasion tool at correct
point and at a velocity aproximating that of a normal hand swing.
Repairability at that point brings various opinions. Phrawg
Posted: Tue Mar 14, 2006 12:10 am
by PINEAPPLE
I have HT1000 JEDI mics for sale used or new in the BOX at very reasonable prices............reply if interested....
Posted: Tue Mar 14, 2006 11:41 am
by wavetar
They pop open in a vice fairly easily...make sure your face isn't in the way!
Todd
Posted: Tue Mar 14, 2006 12:00 pm
by explorer1046
after they are popped open, do you have to hot glue them back together?
Posted: Wed Mar 15, 2006 10:40 am
by phrawg
or epoxy.... even some cyanoacrylate (super glue) might work. Phrawg
Posted: Wed Mar 15, 2006 10:48 am
by Tony Soprano
wavetar wrote:They pop open in a vice fairly easily...make sure your face isn't in the way!
Todd
This works for the Visar mic, too....but what do you do with it once it's open? Not much!
Posted: Wed Mar 15, 2006 1:13 pm
by phrawg
WOW I just realized that last post here was #500.
oh well no big deal compared to those multi thousand fellows. Phrawg
Posted: Wed Mar 15, 2006 1:25 pm
by FF/EMT/KC2NFB
i opened one by prying it open around the edges. i have only done it to one and it opened fairly easy with very little damage. i used crazy glue to close it and you cant tell it was opened unless you look realy close. but as stated above they are sealed units not intended to be opened.