Batboard

I have an XTS Public Safety Mic thats apparently missing the center pin on the mic side of the part that connects to the adapter. So I have two questions:

1. Is it possible to open the connector and replace this part?
2. If so, anyone have the part number so I can order one?

This thing came from ebay so who knows why the pin is missing. I havent tried taking the connector apart yet.

Thanks in advance,

Mike

I have a couple of extra P.S. mics for XTS if you need one.

SG

Thanks for the offer. I would rather, for now, try to fix this one.

Does a manual exist for this thing?

Mike

Motorola will sell you a replacement cable harness, likely more than you can buy a used replacement for.

Those small parts arent available individually, but rather as a kit.

Jason wrote:Motorola will sell you a replacement cable harness, likely more than you can buy a used replacement for.

Those small parts arent available individually, but rather as a kit.

Do you have a p/n for the kit? It is at least worth getting a price off of MOL.

Thanks,

Mike

Ill see if i can find one for you.

Did some reasearch on this for you, it appears the cord assembly is not available, as it requires a factory test procedure before it ships. An MSS can probably get it, IMHO. In fact, the parts are however, at least they do have a part number, not sure on availability. Call AAD (well, what used to be) they should be able to get you a price.

The previous commentary about the small parts not being available was incorrect. The standard JEDI NMN6191/6193/6193SP03 mics are not repairable, but only can have the cordset, ptt lever, and clip replaced.

Here are a few screenshots I made for you, and the group. Should be handy to keep on hand.

As always all materials are copyright Motorola, Inc.

Great, thats exactly what I was looking for!

Thanks a lot!

Mike

I have one of these which I disassembled to repair. It was fairly easy to take apart, however, after I soldered the rf cable to part 47 show in the screen capture above, it still did not work. I too looked on MOL for a replacment cable to no avail. That mic is still sitting on my bench and still will not receive any RF from the antenna, other than that, it works fine.

Talk to Grem467 (Marc) he told me that some of the XTS RF adaptors are defective (center pin is broken internally) and they wont pass RF. I had one I was using on a XTS3K with XTSMVA no RF either.
For whats its worth

Fowler

Good thought, but I tried two different rf adaptors and the PSM still does not work.

is there a place to get cheap RF Adaptors for the XTS PS mic?