Page 1 of 1
Posted: Sun Oct 14, 2001 3:06 pm
by ScannerDan
What is inside a Uhf Mdl# L44SUM700BT, repeater Desktrac ? Is it a maxtrac ? What type of RSS is used to program it?
Thanks
Dan...
Posted: Sun Oct 14, 2001 6:30 pm
by Al
Actually, there are two Maxtracs inside. Usually, one has no PA/heatsink, and the other is a full Maxtrac chassis. You use Maxtrac RSS to program and align the individual radios and Desktrac RSS to program the repeater characteristics.
Posted: Sun Oct 14, 2001 7:31 pm
by jim
Which RSS is used to configure the rear DB-25 in/out connector configuration?
Posted: Mon Oct 15, 2001 6:00 pm
by Al
Neither. The pinouts of both accessory connectors, J2(external speakers) and J3(I/O) are hardwired and changeable only by adding or removing "accessory" boards like telephone interconnect, etc. Even the repeater TOT is only settable via a jumper plug on the front panel board. It *may* be possible to reprogram the individual Maxtrac accessory connectors(of which only one is used, as I recall) via the Maxtrac RSS. But I've never had to do this so am uncertain.