Page 1 of 1
Maratrac question
Posted: Sun Mar 26, 2006 4:32 pm
by n5tbu
http://batlabs.com/maratrac.html
Anyone know if the reciever is powered up with this"programming without a control head" cable?
mod
'programming without the control head
Posted: Sun Mar 26, 2006 7:53 pm
by Will
Yes, the receiver IS powered up using the following "Programming without a control head".
Pin 17 is power ground
Pin 13 is on control, ground turns on the radio
Pin 4 is A+ for the receiver and exciter
Pin 19 is A+ for the transmitter PA
The receiver is working in this configuration but there is no Volume control.
Pin 3 & 5 are the speaker
Pin 1 is volume control High
Pin 15 is volume pot wiper
Pin 2 is volume control ground
There will be low level audio on the Programming/Mic jack, just like the Maxtrac. My test cable has a telephone receiver to monitor the audio.
Posted: Mon Mar 27, 2006 2:39 am
by n5tbu
Thanks Will! That's exactly what I needed:low level audio.
mod
Posted: Wed Oct 18, 2006 12:57 pm
by n5tbu
I also need Mic Hi and PTT......I dont have a book,and am working on a project.
mod
Posted: Wed Oct 18, 2006 1:34 pm
by Will
Ok'y dokey..
Mic high is pin 14, use a coupling capacitor, + to pin 14. Mic line has 9 volts bias and is about 600 ohms impeadance.
MIC LOW is pin 2
PTT\ is pin 12
Posted: Wed Oct 18, 2006 2:40 pm
by n5tbu
Many thanks again, Will!
mod