Page 1 of 1
HT1000 not Xmit over Ch 9
Posted: Sun Apr 02, 2006 9:13 am
by jwb8734
I have a HT1000 that will not xmit on channels 9-16. The RSS is showing it is there.
Posted: Sun Apr 02, 2006 10:10 am
by Doug
The way it sounds to me is that the individual mode is not turned on. On your mode screen after the mode number make sure that yes is entered under the heading of programmed.
Doug
Posted: Sun Apr 02, 2006 12:22 pm
by jwb8734
When I press the PTT the LED o nthe top comes on so I know it's xmitting. I even used a codeplug from another radio, nothing.
Posted: Mon Apr 03, 2006 9:47 am
by wavetar
I'm willing to bet the selector switch is bad, and channels 1-8 are repeating in positions 9-16. Can you check it to see if that's the case?
Todd
Posted: Mon Apr 03, 2006 4:18 pm
by jwb8734
wavetar wrote:I'm willing to bet the selector switch is bad, and channels 1-8 are repeating in positions 9-16. Can you check it to see if that's the case?
Thank You Todd.
That is what it was. Are you saying it needs a new selector switch?
Posted: Mon Apr 03, 2006 4:44 pm
by wavetar
Either that, or the flex assembly may possibly have cold/broken solder connections at the switch. There are a few other possibilities, but they are far less common.
Todd