Batboard

Posted: **Fri Apr 21, 2006 9:41 am**

Hello,

I have a question:
I have an Astro Saber I VHF which is IBME / digital mode. Then I have an Astro Saber III VHF which has analogue operation only.
If I change the housing incl. display-unit do I make a IMBE Astro Saber III VHF and a Astro Saber I analogue only out of them?
If yes, do I have to change any settings with the CPS?

Thanks

Posted: **Fri Apr 21, 2006 1:11 pm**

put the display and housing on the ASI.

Frankenflash it with Model III information

that's all..

CPS... lol...

-Josh

Posted: **Fri Apr 21, 2006 1:18 pm**

There is a little more to it than that to do it properly.

Contact me on AIM.

Jason

Posted: **Fri Apr 21, 2006 9:40 pm**

How can I do it? If I put the display on the AS I and then power the AS on, "SELF TEST" appears but the radios doesn´t power on any further.
How do I Flash the radio with Model III information?

Thanks

Posted: **Sun Apr 23, 2006 4:17 pm**

KB9KST wrote:There is a little more to it than that to do it properly.

Contact me on AIM.

Jason

You're right... I overlooked saving the original soft-pot information first

Batboard

Astro Saber I with IMBE, AS III without IMBE

Astro Saber I with IMBE, AS III without IMBE