Page 1 of 1
Saber III parts swap
Posted: Sat Apr 22, 2006 5:39 pm
by racerman1cars
I am sure this has been asked and answered on here before. Can a 403-433 systems Saber be converted to 438-470 by switching module? I have a good working 438-470 Saber I and found a 403-433 systems Saber and was hoping I could change modules. Thanks
Posted: Sat Apr 22, 2006 10:16 pm
by Grog
If someone could post pics of the swap, that'd be better
Posted: Sun Apr 23, 2006 2:16 pm
by GlennD
I have converted around half a dozen 406Mhz Systems Saber I to 438Mhz Systems Saber III by changing out the front shield assy, synthesizer, pa, rf-mixer, and antenna switch modules. After reprogramming and realignment they worked fine.
As a test I tried one with the orignal pa and antenna switch modules. It seemed to work ok but since I had a full set of modules I changed them out. The highest frequency we use is 465.5Mhz.
Saber
Posted: Sun Apr 23, 2006 2:20 pm
by racerman1cars
My Saber that was going to use the modules out of is a standard saber not sys Saber, does that matter? Steve
Posted: Sun Apr 23, 2006 3:22 pm
by FF/EMT/KC2NFB
no it does not matter. the modules are the same in the saber and system saber. i have done the swap on 5 or so with no problwms.