Page 1 of 1
Maratrac volume problems
Posted: Thu Jun 01, 2006 5:06 am
by arlojanis
I have a VHF MaraTrac that the receive audio goes away and will only come back if power is cycled. What is causing this?
Posted: Thu Jun 01, 2006 11:46 am
by jim
I had one that did this and it was a speaker that was too low of an impedance.
Posted: Thu Jun 01, 2006 4:19 pm
by Will
And or a ground on one of the speaker leads.
You did not tell us which configuration you have???? A5, clamshel or advanced head.
Posted: Fri Jun 02, 2006 4:57 am
by arlojanis
Advanced head.
Posted: Fri Jun 02, 2006 8:08 am
by Max-trac
C551 on the logic board is a weak point in these radios (maxtrac,radius,gm300,maratrac).
It could be flakey.
Read more about it here;
http://batboard.batlabs.com/viewtopic.p ... xtrac+c551
Or do a search on "C551" for more possibilities...