Page 1 of 1
SPECTRA HELP!!!!!!!
Posted: Fri Jun 09, 2006 5:01 am
by low-band
Hi all, i set up my spectra for Zone Enable and when i set my zones and put it in scan every channel goes into carrier squelch...and there is a longer squelch tail than normal??? Can anyone advise me what to Enable OR Disable in the RSS?????
Posted: Fri Jun 09, 2006 6:24 am
by Josh
It's in one of the numerous scan options screens, I think the one on the 'zone' screen, you must enable "PL scan" or something similar, which will allow the radio to scan w/o benig n monitor.
Posted: Fri Jun 09, 2006 2:20 pm
by Will
Coded Squelch Scan... ENABLED
on each mode you need scaned in / with PL.
This is set in the CHG/VIEW: MODE: OPT 1
F7 when in the CHG/VIEW MODE screen
MODE 001 --------
SCAN.....................Channel
Scan Button Control......Active
Coded Squelch Scan......Enabled <<<<<<<<<
Talkback Scan..........Disabled
CODED SQUELCH.......Conventional
Reverse Burst/TOC...... Enabled
UnMute/Mute Type........Std/Std
spectra help
Posted: Mon Jun 12, 2006 6:12 am
by low-band
Thanks guys i got it!!!!!!! You guys are the best!!!!!! Kevin