Batboard

Looking for a cable part number. The cable goes from the 2670 D KVL connector to an XTS radio. Parts department still searching.

I think you will be waiting for a long time
Please explain what you are trying to achieve.
The R2670 does not load keys to a radio

I can load different keys that are stored in the 2670 D into the radio other than the standard test key provided if I had the cable. The manual states that it can be done if the you had the right cable.
I can load from the KVL to the 2670 already from my existing cable.
The test center had a part number and a cable in hand but the part number was obsolete. They are still checking.

It's my understanding that the R2670 cannot load keys to the radio
You load the radio with a key and the 2670 with a key and then do the testing.
Also the 2670 is only in version B from memory.
Just had mine calibrated and the latest firmware upgraded.
There something a long time back with the 2014? that loaded a default key to the radio but I think that was phased out.

The manual states this in the Securenet section page 158 and further on page 173.

Now you've done it.
I'll have to find my manual now!

Oh no Mr. Bill!!!

They stated that at one time they had a cable to go from the 2670 service monitor to an MTS radio but now they do not support that anymore. I advised them that the manual stated that it could be done with the appropriate cable, they stated that they probably never up-dated the manual since its printing reference that particular item. He advised that this has never come up before. Oh well on to more important things.

I'm still looking for my manual.
I use Auto Test software so I rarly look at what the radio is doing anyway.
Just plug and play