Page 1 of 1
M120 and TinyTrak3...
Posted: Mon Jun 19, 2006 12:39 pm
by Jonathan KC8RYW
TinyTrak is looking for a high-level COS.
M120 is giving a low-level COS.
I don't think the M120's I/O is programmable in RSS.
Any easy suggestions?
Posted: Mon Jun 19, 2006 1:12 pm
by kb0nly
You should be able to set it for active high in the RSS instead.
If not the worse you will have to do is just fab up a circuit to change it.
Posted: Mon Jun 19, 2006 3:23 pm
by ve3nsv
Try between pin 7 (ground) and pin 1 (int Sp -) with the jumper between pin 15-16 removed. I was able to get an active hight 6.5v swing on my M10 that is used for an IRLP node. Only becasue I was too lazy to switch the jumper on the IRLP board after switching from a Pheonix.
