Page 1 of 1
Convert GP300 to DTMF Capable
Posted: Thu Jul 06, 2006 7:47 pm
by goldvetter
I know that this is possible. Can anyone help me out here? I have the case with the electronics, just need to enable it in software somehow. Thanks
Posted: Thu Jul 06, 2006 9:22 pm
by AEC
All you need is the DTMF case and solder the header onto the lower section of the board, at the bottom.
Many times I have seen the leads soldered directly to the board, as well as a small header soldered to facilitate easy case removal as well.
Even if you have to solder the leads on, the task should take you no longer than an hour start to finish, then all you would need to do is enable the option in the RSS and away you go.
You might prefer to read the radio first, as it may report the DTMF addition so you wouldn't need to worry about the RSS option.
Posted: Fri Jul 07, 2006 4:35 am
by goldvetter
Thats the thing. I dont have the option in rss. Its not there.
Posted: Sat Jul 08, 2006 8:33 am
by goldvetter
Can anyone help me out here
Posted: Sat Jul 08, 2006 2:50 pm
by W6JK
I haven't done this, but it seems possible that you need to change the model number of the radio so the RSS knows it should have this feature. I don't know what the new model number should be, however, nor do I have any clear idea how to change it.
Jeff
Posted: Sat Jul 08, 2006 8:15 pm
by goldvetter
Seems like someone said I need a codeplug from another GP300 VHF with phone dtmf capability.
Posted: Wed Jul 12, 2006 5:11 pm
by 60hzEE
From my recollection, DTMF is only a 16CH radio feature. So, follow the procedure on the Batlab Thread for changing it to a 16CH radio. Remember, most 2CH radios are forever 2CH radios.
The DTMF front cover has contacts on the bottom that mate up with the board. No soldering required. Just put the old guts in the new cover, tell it is now a 16CH radio, and select phone options in the software for each mode and its done.
Lee
Posted: Wed Jul 12, 2006 9:28 pm
by VE9MP
I have a 8 channel GP300 with DTMF.....it started out as a 2 channel P110 though
Posted: Thu Jul 13, 2006 5:01 am
by RadioSouth
I've never done a GP300 DTMF conversion but I can add these tidbits:
I looked in the GP300 catalog and there were DTMF retrofit kits available for all but 2 ch. models (8, 16 plus that odd 8+2 model). Being these were offered as after time of sale retrofits (or as factory options) there has to be a way to enable it without any bit banging.
I have a couple of GP300's that had been set up for DTMF-ANI signalling
so the likely place to look for keypad DTMF would be in the signalling menu (also where the MDC-1200 options would be located).
I did have a DTMF P110 apart (identical board and frame) and the shield had a cut out to access tabs on the main board so when the DTMF front was pressed on it would make contact.
Posted: Sat Jul 15, 2006 9:46 pm
by goldvetter
Will try to make it a 16ch and see if the option pops up. Thanks
DTMF GP300
Posted: Sun Jul 16, 2006 11:15 pm
by proff
Use a GP300 5 tone
keypad board, the contacts are on the bottom of the main board