Page 1 of 1
Saber programming
Posted: Tue Jul 18, 2006 12:31 pm
by ASTROAL
I have ver.#07 software for saber ,I am unable to save file after reading radio.When I try to save the file it says no elements and no file.I put in the model # where it says file,then I hit f2 is that correct or am I supposed to put something else there?
Posted: Wed Jul 19, 2006 6:30 pm
by AEC
If you simply copied the entire RSS to disk, you did not create a path for the archive once the main directory was created.
You can select 'default' and see if there was 'something' the RSS used as it's archive path, or you can create your own and press F8 to save it, and if that works, try saving the codeplug again.
There are several Saber versions I have had that did not have the HD installation as part of the initial setup, but every path can be created once you have the basic file information saved to disk, and you are in that directory as well.
I can bring up my RSS manual, but it takes a while, but I may be able to Email you the information from the manual.
saber programminig
Posted: Thu Jul 20, 2006 10:36 am
by ASTROAL
Thanks.I have the rss manual and I will have to check the installation process again.
saber programming
Posted: Thu Jul 20, 2006 2:29 pm
by ASTROAL
The problem is solved.I selected the default setting and it brought up the codeplug I previously saved.Thanks again for your imput.
Posted: Thu Jul 20, 2006 5:09 pm
by AEC
YEE HAA!!
Another radio brought back from the dead!
Glad you got it running again!