Batboard

Hello all i am not that up on what the minitor II can do as far as functions but is there an easy way to make the pager monitor the freq without haveing to hold down the button ?

Thanks Mike

For a 1 frequency pager
Bell - Tone alert no monitor
Ch1 - monitor F1 with alert
Ch2 - monitor F1 no alert

For a 2 frequency pager
Bell - Tone alert F1 no monitor
Ch1 - monitor F1 with alert
Ch2 - monitor F2 no alert
It all depends on how the pager was setup, but what I listed is the with factory standard options.

Ok thanks for the responce, guess i should have stated what i have which is a 1 channel pager with vibe and bell alert selevtable via a switch on the top, actualy it is a director II.

Was hoping for a cut jumper so and so and bridge jumper so and so. I can do without the vibe if it has to go so the bell/vibe switch can function as monitor/alert i guess you would call it.


>For a 1 frequency pager
>> I am guessing this is how it is set now. Bell - Tone alert no monitor
>>>Would like this i am guessing. Ch1 - monitor F1 with alert

Thanks Again Mike