Page 1 of 1
SPECTRA REMOTE HEAD QUESTION
Posted: Wed Jul 26, 2006 8:58 am
by STEVE W
I have a mid power remote mount Spectra A7. The reomote head is now mounted on a HLN6432A plastic back and it works fine, when I changed it to a B version the five top row buttons over the display do not work, they beep when they are pushed. The head is the advanced version and the firmware is 5.21. Do I have a bad part or is there ia differnece in the versions. I do know it was originally used on A4 ASTROS that were in fire service.
THANKS,
Steve
Posted: Thu Jul 27, 2006 8:34 am
by Rick Rock
Are you saying you switched the backing (HLN6432) and got the error?
spectra control head
Posted: Thu Jul 27, 2006 9:35 am
by STEVE W
I switched from the HLN6432A to a HLN6432B that is when I got the error
Posted: Thu Jul 27, 2006 9:48 am
by Rick Rock
That shouldn't have caused any issues- have you checked the pins on the back of the head itself to make sure none bent while putting it in? All the rev. indicates is a upgrade version, but as long as the main part# is the same, it 'should' be fine... I've not heard of those going bad, I wonder if there's water damage somewhere...
spectra head
Posted: Thu Jul 27, 2006 10:45 am
by STEVE W
The unit looks new there is no "liquid" discoloration on any of the lables or gasketing
Re: SPECTRA REMOTE HEAD QUESTION
Posted: Thu Jul 27, 2006 3:28 pm
by Will
STEVE W wrote:
the five top row buttons over the display do not work, they beep when they are pushed
THANKS,
Steve
The key is the buttons Do the BEEP when pushed, that would indicate they are not programmed correctly. So the head up IS reading the key presses, and the cable should not have any interaction, but we have seen may things on Spectras that "does not compute".
Next step: Do an Control Head TEST, KEY test.
Spectra remote head back
Posted: Sat Jul 29, 2006 5:54 am
by STEVE W
I give up , I tried again this time running the rss to run the code plug again, same thing buttons beep but do not work. Put the original A version back on and put the part back in the cabinet , may I will heave it the next time I clean out the junk bin where I put it.
Spectra remote head difference
Posted: Wed Aug 02, 2006 10:25 am
by STEVE W
I actually did not give up, I compared the pc boards and it hit me, the Blenderman site thought that theim\r might be a diiference in the jumpers, sure enough, the B version only had 1 jumper instead of 2 on the top right . I soldered a jumper and now I have full usage of the top row of buttons. I guess stuborness and beginners luck paid off.
Thanks
Steve W.