Wont transmit on specific frequency

This forum is dedicated to discussions pertaining specifically to the Motorola ASTRO line of radios (those that use VSELP/IMBE/AMBE), including using digital modulation, digital programming, FlashPort upgrades, etc. If you have general questions please use the General or Programming forums.

Moderator: Queue Moderator

Post Reply
Alex663
Posts: 108
Joined: Thu Dec 09, 2004 5:42 pm

Wont transmit on specific frequency

Post by Alex663 »

I have an XTS3000 Model II that I just got finnished programming and have found that on 1 channel (153.92) I can recieve but cannot transmit. I made sure that the RX only was unchecked and even deleted and added the channel again (also putting it on a different channel) with no luck. Any ideas? I dont have any issues with any other freq all of which start at about 154.00 to 160.000. If its a hardware issue what is the going rate for repairs? Thanks!
Top
User avatar
Pj
Moderator
Posts: 5147
Joined: Sun Sep 09, 2001 4:00 pm
What radios do you own?: X9000 thru APX

Post by Pj »

Any "bonk" sounds from the radio? LED light up? Steady, flashing, etc?
Lowband radio. The original and non-complicated wide area interoperable communications system
Image
Top
Alex663
Posts: 108
Joined: Thu Dec 09, 2004 5:42 pm

Post by Alex663 »

The transmit LED lights up red and no bonk sounds but I do get my PTT sidetone.
Top
Post Reply

Return to “Legacy Batboard Motorola ASTRO (VSELP/IMBE/AMBE) Equipment Forum”