Page 1 of 1
CDM1250 DTMF
Posted: Sat Sep 09, 2006 12:18 pm
by MHz
We're receiving a fleet of vehicle with CDM1250s and will use DTMF for activating a remote device. Can DTMF codes be pre-sets programmed once or must you always use a keypad mic to enter the code each time its needed?
Posted: Sat Sep 09, 2006 5:47 pm
by MassFD
If you only need to do 1 set of DTMF tones per vehicle you can set up a personaity with a Phone System and put your DTMF sequence in as an access code then program a front button to activate the phone system.
When you press the button the DTMF you programed as access code will be transmited.
As far as the DTMF Mike goes, I have never used one so I cannot say what it can do.