MCS-2000
Moderator: Queue Moderator
MCS-2000
Hello, i have an Mcs-2000 mobile radio model 1 with speaker etc all in one unit. this vehicle is hooked up to our ambulance. usually when we turn the ambulance on the radio stays on the last channel it was on which should always be channel 6. but now when you turn it on, it defaults to channel 1. regardless if you change it to 6 again, it will flop back to 1 the next time its turned on. any ideas before i need to call for service?
.
yes, you can program the home channel in CPS to channel 6....
doug
doug
BRAVO MIKE JULIET ALPHA
"You can do whatever you want, there are just consequences..."
IF SOMEONE PM'S YOU - HAVE THE COURTESY TO REPLY.
"You can do whatever you want, there are just consequences..."
IF SOMEONE PM'S YOU - HAVE THE COURTESY TO REPLY.
Re: .
That will only make channel 6 the "home" channel for pressing the "home" button. It does not affect power-up channel.batdude wrote:yes, you can program the home channel in CPS to channel 6....
doug
It sounds like the radio's main power wiring is going to the master on/off in the ambulance. It should be run to constant power, with Pin 15 of the accessory connector run to the switch. The radio will also need it's ignition sense option programmed to "soft power off" in the RSS/CPS.
Todd
No trees were harmed in the posting of this message...however an extraordinarily large number of electrons were horribly inconvenienced.
Welcome to the /\/\achine.
Welcome to the /\/\achine.