Batboard

found this on the net but if it's out of line please remove

How to modify CPS for "off" check of the password
On example CPS R06.03.02 for ProRadio Waris MDC.

HexWorkshop o Winhex is required or any hex editor.

Open for editing file ProRadio.exe from folder with
installed CPS R06.03.02

Go to the offset 00240EEA from the beginning of a file
There you will see value 741C. Replace on EB1C.
Save a file . Be sure to put it back in the same place.


When the Password Screen comes up, just press enter.
Go into the CPS password config menu and the password
is displayed.

MORE:

VERSION OFFSET REPLACE
CPS R02.01.02 001316B1 741C--> EB1C
CPS R02.01.03 00131BF1 741C--> EB1C
CPS R06.01.00 00239F2A 741C--> EB1C
CPS R06.02.05 0024029A 741C--> EB1C
CPS R06.03.02 00240EEA 741C--> EB1C
CPS R06.04.00 002412AA 741C--> EB1C
CPS R06.05.03 0024429A 741C--> EB1C

Note: ELProRadio.exe = (Entry Level Professional Radio CPS).
ProRadio.exe = (Professional Radio CPS)

I believe this was previously discussed in this thread -

http://batboard.batlabs.com/viewtopic.php?t=51318

is there anything avaulable or will it be the same procedure for the
Commercial Series Customer Programming Software
Version R02.04