Batboard

I have programmed hundreds of CDM1550's over the years. I just found one that is messing with me. When I write to the radio the 1st zone comes up as LS trunking despite being a conventional bank. It only has the 1st channel in that bank also.

After this happened a few times I deleted the zone rebuilt it and wrote the radio again. As you can imagine it is still showing up as a ls trunking zone.

ANY HELP?????

Make sure none of the conventional channels in the zone have the option board enabled in the advanced tab. If all else fails, send me your codeplug & I'll have a look at it.

[email protected]

Thats the problem!!!!!! THANKS

Nice catch.

Sweet, glad it was that easy.

Todd

Ditto on the solution; the first one I had to do it took me about 2 hours to figure this out.