Page 1 of 1
MCS2000 H38 upgrade help
Posted: Sun Oct 15, 2006 4:18 pm
by zulu
Does anyone know if it is possible to upgrade a H35 to a H38 using a H38 codeplug and just forcing it into the radio if it is the same model?
If so what CPS/RSS can this be done with?
Is there anyway of converting a CPS codeplug to a DOS RSS acceptable codplug?
Thanks in advance
Posted: Sun Oct 15, 2006 4:23 pm
by wavetar
Yes, it can be done. You need some form of LAB RSS, regular RSS cannot do it.
Little known fact...you can use a CPS codeplug for this purpose, just the same as a DOS RSS one...makes no difference with LAB.
Posted: Mon Oct 16, 2006 11:24 pm
by zulu
thanks
Posted: Tue Oct 17, 2006 4:57 am
by jmr061
Be careful however if your MCS2000 has newer firmware. They added the dreaded fail 1/93 issue in the very later releases.
Jason
Posted: Thu Oct 19, 2006 11:49 pm
by n3obl
Is there a different lab for MCS2000(not same as MTSX lab) also did moto implement the toolproofing on MCS2000??
Frank N3OBL
FF/EMT
Posted: Sun Oct 22, 2006 6:06 am
by wavetar
n3obl wrote:Is there a different lab for MCS2000(not same as MTSX lab) also did moto implement the toolproofing on MCS2000??
Frank N3OBL
FF/EMT
There likely is an actual MCS2000 LAB RSS within Motorola, but I've never come across it. Not that it matters much, the MTSX LAB will work with the MCS2000 for forcing in codeplugs anyway.
Only the very last couple of firmware firmware versions released for the MCS2000 had toolproofing implemented. I don't know the firmware versions off-hand...but 99.9% of MCS radios out there you don't need to worry about it.
Todd