M400 run-time error

[RidgeRunner]

Anyone know if I can fix this. I had two copies of m400 both verison 1 They say run-time error 6003 interger divide by 0 Can I fix this or do I need to optain another copy of the software.

Thanks
Robert

[Al]

I don't believe a hundred copies of the version 1 RSS would help you. Generally, the integer divide by zero error message means you're trying to use a PC that's too fast. I would try the oldest PC that you can lay hands on, preferably an 8088 or nothing newer than an 80286 running at 15 Mhz or so. I think your error problem will go away if you do.

[MotoMax300]

The fastest I have that able to run on is a 386 sx 16

[Max-trac]

Yes, the computer is too fast. Hit the turbo switch, or see if you can boot to slow mode in the cmos.
Try a newer version of the RSS or maybe even Maratrac RSS.

[Batwings21]

That is exactly what the problem is, if you have a turbo switch, turn it off. If not if its a 486, you might be able to get it to run by typing m400 to start the program, and then immediately after hitting enter hit pause, then alternate between hitting enter and pause really fast. That used to work on my old 486. Or if you are even newer, use a program called mo-slo. I used that a couple of times.

[RidgeRunner]

horray it worked I used turbo! thanks guys!