Page 1 of 1
2007 Yukon XL, Yukon, Suburban
Posted: Sun Oct 29, 2006 7:18 pm
by kdean7
Anyone had the chance to remove a headlight on one of these yet? Going to mount strobes but can't figure out how to remove the headlight assembly.
Any ideas?
Posted: Wed Nov 01, 2006 7:56 am
by otter9309
Hide-a-ways will do better in the lower driving lights (if you have them). Smaller, tighter spots tend to perform better with hide-a-ways. Headlights will drown out the strobes, stick with a headlight flasher up top.
S.
Posted: Wed Nov 01, 2006 11:27 am
by kdean7
actually planning them for the turn signals. Didn't specify the difference cause the whole thing is one assembly.
Any idea how to remove the assembly?
Posted: Wed Nov 01, 2006 12:47 pm
by otter9309
No, I am not sure. I was just commenting on the placement.
S.
Posted: Wed Nov 01, 2006 6:14 pm
by Jay G.
I just did a 2007 Yukon. Two 10mm bolts on top where you can see them, and one hidden in the wheel well. also 10mm. You need to remove the 2 7mm bolts and a few push type retainers in the wheel well to see the one bolt.
I drilled the strobe in right below the oem marker bulb. Drill a 1 1/4" hole in the outer shell, then the 1" hole in the inner shell. I used the push in type strobe bulb, and sealed it with marine grade silicone. Came out very nice!