Page 1 of 1
Saber 1
Posted: Sat Jun 29, 2002 6:32 am
by aamster
I have a UHF Saber 1 H44QXN7139CN. The radio is dead there is no sq noise and no xmit. Putting a power supply on the voltage input shows that when the radio is on there is about 10 ma showing which I assume is so you can program the radio. Any ideas why the radio is dead?
Posted: Sat Jun 29, 2002 8:43 am
by Monty
HI
Chances are:
1. The Radio has a bad code plug.
Solution:
Build a new code plug suitable for the radio, and
try [ writing ] to the radio
2. The Radio may have a loose or defective
module.
Solution:
Make sure all the modules are secure, if you
have a spare radio and want to gamble, do a module
swap.
3. The Radio has a Major Componet Failure.
Solution:
Either try and find someon local to fix it if you are not
able, [ Sometimes ] I can fix them for 125.00 depending
on the Componet that has failed.
Monty