Page 1 of 1
911EP mellinium help needed
Posted: Wed Nov 15, 2006 8:00 pm
by astroman
I need to know what the pin-out for the programming cables I have the soft ware but I lost my cable If anyone knows the pin-out please contact me .
Posted: Thu Feb 01, 2007 8:49 am
by Double_Deuz
What do you mean by pinout, and which model do you have.
If you are using a CID box they are on the box themselves
if you want to know which one is TX and which is RX I can look that up for ya.
Let me know
Problem solved
Posted: Fri Feb 02, 2007 6:48 pm
by astroman
I have got the cable I need now
Posted: Sat Feb 03, 2007 9:54 am
by Bob
Double_Deuz wrote:What do you mean by pinout, and which model do you have.
If you are using a CID box they are on the box themselves
if you want to know which one is TX and which is RX I can look that up for ya.
Let me know
The newer CIDs for the Millennium have a programming port on them where you plug in a PC to do pattern selection, etc.
Posted: Wed Feb 07, 2007 11:22 am
by astroman
That is what I needed and my 911EP rep got the cable for me so i am set now.